Pioneer PDP-4270XA User Manual

Watching TV 06
21
En
English
Chapter 6
Watching TV
Important
• Before watching broadcast channels, the built-in TV tuner must be
set up. See Setting up TV channels on page 25 for how to do this.
Turning the power on
• To turn on the system, press POWER on the bottom-left of
the front of the plasma television.
The POWER ON indicator lights blue.
• To switch the system back into standby, press  on the
remote control unit or STANDBY/ON on the plasma television’s
control panel on the right-hand side.
The STANDBY indicator lights red.
• You can then turn on the system again by pressing  or 0 to 9 on
the remote control or STANDBY/ON on the plasma television. If
you press 0 on the remote control unit, images come from the
INPUT 1 source. If you press 1 to 9, TV images display.
• You can also press POWER on the plasma television to turn off the
system. However, you cannot then turn on the system again by
pressing the buttons on the remote control unit or STANDBY/ON
on the plasma television.
Note
• When the system is placed into standby mode, the main power
flow is cut and the system is no longer fully operational. A minute
flow of power feeds the system to maintain operational readiness.
• If you are not going to use the plasma television for a long period
of time, be sure to remove the power cord from the power outlet.
Plasma television status indicators
The table below shows the operational status of the plasma television.
You can check the current status of the system with the indicators on
the plasma television.
For other than the above, see Troubleshooting on page 44.
Changing channels
Use the remote control or the control panel on the right-hand side of
the plasma television to change channels.
Indicator status System status
POWER ON STANDBY
The power cord of the plasma television has been
disconnected. Or, the power cord of the plasma
television has been connected but the POWER button
of the plasma television is off.
Power to the system is on.
The system is in the standby mode.
8
AAA
STEREO
10:00
STANDARD
FULL
Channel display

Pioneer PDP-4270XA Specifications

General

3D	No
Depth	115 mm
Width	1040 mm
Height	679 mm
Weight	31500 g
Tuner type	Analog
Pixel pitch	- mm
Product color	Black, Silver
Noise reduction	Yes
RMS rated power	26 W
AC input voltage	220 - 240 V
Display diagonal	42 \
Channels quantity	99 channels
AC input frequency	50 - 60 Hz
Display brightness	1100 cd/m²
Display resolution	1024 x 768 pixels
Display technology	Plasma
Number of speakers	2
Teletext standards	Top-text
SCART ports quantity	3
USB 2.0 ports quantity	0
Annual energy consumption	- kWh
Display diagonal (metric)	106 cm
Analog signal format system	NTSC, NTSC 3.58, NTSC 4.43, PAL, PAL 60, PAL BG, PAL DK, PAL I, SECAM, SECAM B/G, SECAM D/K, SECAM L
Power consumption (standby)	0.3 W
Power consumption (typical)	287 W
Digital signal format system	-
Sound enhancement technology	FOCUS, SRS, TruBass
On Screen Display (OSD) languages	CZE, DAN, DEU, DUT, ENG, ESP, FIN, FRE, GRE, ITA, NOR, POL, POR, RUS, SWE