Useful adjustment settings 09
37
En
English
Note
• If you fail to enter the correct password three times, "Invalid
password." appears, and the menu is closed. In order to display the
password entry screen again to unlock the password, select the
blocked channel or open the menu again.
• If the password entry screen disappears before entry, you may
recall it by pressing ENTER.
Changing the password
Use the following procedure to change the password.
1 Press HOME MENU.
2 Select “Setup“ (/ then ENTER).
3 Select “Password“ (/ then ENTER).
The password entry screen appears. Enter the current 4-digit password
using buttons 0 to 9.
4 Select “Change Password“ (/ then ENTER).
5 Enter a 4-digit password to be newly set, using buttons
0 to 9.
6 Enter the same password that you have entered in step 5.
• If a different password is entered, the operation goes back to step
5 for reentry from the beginning.
• You can try up to three times to reconfirm the new password before
the Change Password screen is automatically exited.
7 Press HOME MENU to exit the menu.
Note
• Take a note of the newly set password and keep it handy.
Resetting the password function
1 Press HOME MENU.
2 Select “Setup“ (/ then ENTER).
3 Select “Password“ (/ then ENTER).
The password entry screen appears. Enter your 4-digit password using
buttons 0 to 9.
4 Select “Reset“ (/ then ENTER).
5 Select “Yes“ (/ then ENTER).
6 Press HOME MENU to exit the menu.
Note
• The above procedure will reset the password to the factory default
(1 2 3 4).
Disabling the password function
Use the following procedure if you want to deactivate the protection
function that prompts password entry.
1 Press HOME MENU.
2 Select “Setup“ (/ then ENTER).
3 Select “Password“ (/ then ENTER).
The password entry screen appears. Enter your 4-digit password using
buttons 0 to 9.
4 Select “Password Setting“ (/ then ENTER).
5 Select “Disable“ (/ then ENTER).
6 Press HOME MENU to exit the menu.
Note
• The above procedure will reset the password to the factory default
(1 2 3 4).
• After disabling the password function, you cannot change the
Child Lock settings. For the Child Lock, see page 26.
• After disabling the password function, you cannot change or reset
the password.
• When you enable the password function again after disabling it,
the factory default password (1 2 3 4) is restored.
Change Password
Please Input New Password.
Reconfirm New Password.
We suggest you write down your password so you don't forget it.
If you forget the password
When the message "Please Input Your Password." is displayed,
press the ENTER button on the remote control unit and hold it down
for 3 seconds or longer.
The password reverts to "1234".
PDP-4270XA
Your password No.:
To Next Page
Loading...
Need help?
General
