122
PDP-433CMX
1234
C
D
F
A
B
E
1
23
4
GSS:
Outputting data on
SETUP items of the menu mode / Integrator menu
• Data are output according to the transmission order and size in the table below.
• This command is valid only in Normal Operation mode, RS-232C Integrator Adjustment mode, and RS-232C Factory adjustment mode.
(Note 1) As for the setting data not related to the current input function/input signal/setting, dummy data are output.
Order Data Contents Size Output Remarks
1 COLOR TEMP 1 byte
1: COLOR TEMP1
2: COLOR TEMP2
3: COLOR TEMP3
4: COLOR TEMP4
5: COLOR TEMP5
(Note 1)
2 DIGITAL NR 1 byte
0: OFF
1: LOW
2: MIDDLE
3: HIGH
(Note 1)
3 HIGH CONTRAST 1 byte 0: OFF, 1: ON
4 PURECINEMA 3 byte Same as the RS-232C command (Note 1)
5 COLOR SYSTEM 3 byte Same as the RS-232C command (Note 1)
6 CLAMP 1 byte
1: AUTO
2: LOCKED
(Note 1)
7 3DY/C 1 byte
M: MOTION
S: STILL
(Note 1)
8 SETTING/VIDEO SIGNAL 3 byte Same as the RS-232C command (Note 1)
9 2X2MODE 1 byte
0: OFF
1 to 4: MG1 to MG4
(See "MAGNIFY")
10 BRIGHT ENHANCE 1 byte 0: OFF, 1: ON
11 HDTV MODE 3 byte Same as the RS-232C command (Note 1)
12 VIDEO INPUT 1 byte
1: COMPONENT1
2: COMPONENT2
(Note 1)
13 Input function 3 byte IN*
14 Screen size 1 byte
0: DOT BY DOT
1: 4:3 (TYPE)
2: FULL (TYPE)
3: ZOOM
5: WIDE
6: 100% display
15 SUB VOLUME (INPUT1) 2 byte 0 to 60
16 SUB VOLUME (INPUT2) 2 byte 0 to 60
17 SUB VOLUME (INPUT3) 2 byte 0 to 60 (Note 1)
18 SUB VOLUME (INPUT4) 2 byte 0 to 60 (Note 1)
19 SUB VOLUME (INPUT5) 2 byte 0 to 60 (Note 1)
To Next Page
Loading...
Need help?
General