Pioneer PDP-5010FD

PDP-5010FD
109
5678
56
7
8
C
D
F
A
B
E
6.2.4 INITIALIZE
NIITILAIZE
IDSEMASL L +()K
IN
EVE
V–D1 3 1060 –NTV HA–B
1
5
10
15
16
1 5 10 15 20 25 30 35 40
To configure sidemask level (To adjust the values, input signal is required).
• To reset each memory values to factory default values. Factory command is "FST".
• When the configuration is set to <NO> and the [ENTER/SET] key is pressed, no action is taken and the menu returns to
previous screen.
• When the configuration is set to <YES> and the [ENTER/SET] key is pressed for 5 seconds, the reset action executes.
Display Content RS-232C
SIDE MASK LEVEL <=> Adjust Side Mask level (Adjustable range: 000 to 255) SML
NIITILAIZE
ATDARESTE
INFALSETUP
<=>
V–D1 3 1060
O
:N
–NTV HA–B
1
5
10
15
16
1 5 10 15 20 25 30 35 40
6.2.4.2 FINAL SETUP (+)
6.2.4.1 SIDE MASK LEVEL (+)
Be sure to disconnect and connect the AC cable after FINAL SETUP.
When replacing the MAIN Assy, the FINAL SETUP is required.
Operation item
No. Function Content RS-232C
6.2.4.1 SIDE MASK LEVEL (+) Configure the color of the side mask. SML
6.2.4.2 FINAL SETUP (+) Initialize flash memorys on virgin product status FST
6.2.4.3 HMG/HG SERVICE MODE Enter HMG/HG SERVICE MODE
−−−
6.2.4.4 Wide XGA AUTO <=> Exclusively used for technical analsyis.
−−−
Note: When there is an altered history due to an open TRAP SW, if the "DISPLAY" key is held for at least
5 seconds on the above menu, the altered history will be cleared and the unit will be back to normal.