Pioneer PDP-5010FD

PDP-5010FD
159
5678
56
7
8
C
D
F
A
B
E
9.3.5 QPW (VIDEO ADJUSTMENT DATA OF THE PANEL)
9.3.6 QPM (PULSE METER VALUE)
Data Arrangement
Data
Length
Output
Example
ECO 3 byte QPW (fixed)
1 Drive sequence 3 byte 60V
2 Standard/nonstandard 1 byte S
3 Type of ABL/WB tables 2 byte T1
4 ABL adjustment value 3 byte 128
5 R-HIGH adjustment value 3 byte 256
6 G-HIGH adjustment value 3 byte 256
7 B-HIGH adjustment value 3 byte 256
15 Center luminance correction 1 byte 1
16 Reserved 1 byte
∗
17 WB interlocked with APL 1 byte 0
18
Transition of protective operations 1 byte 0
19
20
Reserved 2 byte
∗∗
8 R-LOW adjustment value 3 byte 512
9 G-LOW adjustment value 3 byte 512
10 B-LOW adjustment value 3 byte 512
11 R gamma setting 2 byte 07
12 G gamma setting 2 byte 07
13 B gamma setting 2 byte 07
14 Streaking correction 1 byte 0
CS 2 byte 39
15: Center luminance
correction
0 OFF
2 ON (interlocked with APL)
1ON
3: Type of ABL/WB tables
n n: 1 to 4
11, 12, 13: RGB Gamma setting
n 00 to 31
18: Transition of brightness by
protective operations
0 Upper limit state for brightness
1 Brightness being reduced
2 Lower limit state for brightness
3
Brightness being increased
17: WB interlocked with APL
0 OFF
1ON
2
WB interlocked ON/γ OFF
3
WB interlocked OFF/γ ON
1: Drive sequence
50V Video 50 Hz
48V Video 48 Hz
60V Video 60 Hz
72V Video 72 Hz
75V Video 75 Hz
70P PC 70 Hz
60P PC 60 Hz
2: Standard/
nonstandard
S Standard
N Nonstandard
14: Streking
correction
0 OFF
1ON
Command
Format
Effective Operation
Modes
Function Remarks
[QPW] All operations To acquire data on the video setting value Return data: 3 (ECO) + 40 (DATA) + 2 (CS) = 45 Byte
The command QPW is for acquiring the factory-preset data about the video of the panel.
Data Arrangement
Data
Length
Output Example
ECO 3 byte QPM (fixed)
1 Pulse meter B 1 8 byte 00000000
2 Pulse meter B 2 8 byte 00000000
3 Pulse meter B 3 8 byte 00000000
4 Pulse meter B 4 8 byte 00000000
5
6
Pulse meter B 5 8 byte 00000000
CS 2 byte 6E
Command
Format
Effective Operation
Modes
Function Remarks
[QPM] All operations To acquire data on the accumulated number of pulses Return data: 3 (ECO) + 40 (DATA) + 2 (CS) = 45 Byte
The command QPM is for acquiring the accumulated number of pulses of the panel.