Pioneer PDP-5010FD

PDP-5010FD
69
5678
56
7
8
C
D
F
A
B
E
Frequency of
LED Flashing
Major Type Detailed Type
Log Indication in Factory Mode
Checkpoint
Possible Defective
Part
Remarks
MAIN SUB
RETRY Communication line between BCM7038 and MAIN IC6401
Check the startup of the BCM7038 and the communication line with MAIN.
DE-BCM Periphery of BCM7038 IC6401 DE-FE Front-end block (ANT-A) IC6401, U6101
IC6903, IC6401 IC6401, AWV2497 IC7302, IC6401, POD Assy
Check the BCM7038 and its periphery device
DE-CAS
Periphery of VBI slicer
Check the BCM7038 and its periphery device
DE-VBI IC7001
Check the BCM7038 and its periphery device
DE-EP1 Check the BCM7038 and its periphery device TV-G
Check the BCM7038 and its periphery device
HOME-G HNM circuit
DTV middleware TV-GUIDE function (Data from broadcast wave)
DTV application
Check the BCM7038 and its periphery device
DTVMID DTVAPP
TV Guide Home Gallery Middleware Application
IIC communication line between EEPROM and MAIN
Check the communication lines (SCL_EP/SDA_EP).
IC8404, IC8401
PS/RST
DTV communication error BCM7038 is abnormal Tuner1 or Tuner2 Card I/F IC VBI Slicer EEPROM
DTV startup error
–
Blue 11
High temperature of the unit
– TEMP2 –
Temperature sensor or its periphery –
– – –
TEMP2 A shutdown occurs because of high temperature.
Periphery of the temperature sensor TH9091 TEMP2 Periphery of the cable between IO4 and M6 CN8804, CN4004 Check if cables are firmly connected.
Blue 12 Blue 15
Digital Tuner Main EEPROM
DTUNER MA-EEP
Startup of BCM7038 IC6401 Check the startup of the BCM7038 and the communication line with MAIN.
Blue 13
Failure in the power supply
DC-DC Converter power decrease Main EEPROM communication error
Periphery of connector
Check if cables are firmly connected.
CN4111
START
Blue 14
Home Media Gallery
HMG
HMG startup error
RST-MA
M-DCDC
DC-DC converter or its periphery, RST2 IC4403, Q4404 Check if V + 3.3 V_D4 is started. EMG_USB IC4309, Q4304 Check if the voltage at a waveform check point is 5 V.
POWER SUPPLY RELAY
The 12 V power is not output, RST4 POWER SUPPLY Unit Check if V + 12 V is started.
The 6.5 V power is not output POWER SUPPLY Unit Check if V + 6.5 V is started. The 5.1 V power is not output POWER SUPPLY Unit Check if V + 5.1 V is started. EMG_DDC DC-DC converter Check if the DC-DC converter is overloaded. Periphery of the cable between P8 and M3 CN4105 Check if cables are firmly connected. HNM power supply IC4309, Q4304 Check if the voltage at a waveform check point is 5 V.