MakeGONSYNCconnectionsforanAVcomponentwith
outputthathasthesynchronizationsignallayeredontop
ofthegreensignal,
When connecting to INPUT3
0@@
ii ii
Y c_/P_ cRiP_
_oN sYNc_ INPUT3
Make composite SYNC connections for a component
with output that has the vertical synchronization signal
layered on top of the horizontal synchronization signal,
When connecting to INPUT3
@@@@
a a
G _ ra HD
(ON SYNC_ _NPUTS _HtV SYNC_
On screen setup is necessary after connection,
Please see pages 17 to 19,
Notes
• When making G ON SYNC connections, do not make any
connections to the VD or HDjacks If connections are made,
the picture may be not displayed normally
• When us4ng a computer connected by the G ON SYNC
connection, on screen adjustment for G ON SYNC is
necessary (pages 17 to 19)
Please read your PC's instruction manual throughly
When connecting to INPUT4
When using INPUT3, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal
When the output impedance of the component's
synchronization signal is above 75 £_,set this switch to
the 22 k£_ position
On-screen setupis necessary after connection,
Please see pages 17 to 19
Notes
• When making composite SYNC connections, do not connect
anything to the VDjack If connected to, the picture may not
be displayed properly
• On some types of Macintosh components, G ON SYNC and
composite SYNC are both output With this type of
component, please connect using the G ON SYNC connection
(as shown left)
When connecting to INPUT4
ANALOG
On screen setup is necessary after connection,
Please see pages 17 to 19,
On-screen setup is necessary after connection,
<ARE1349,Er/ Please see pages 17 to 19
To Next Page
Loading...
