Connection to a personal
computer
Connection method differs depending on the computer
type When connecting, please thoroughly read the
computer's instruction manual
Before making connections, be sure to make sure that
the personal computer's power and this unit's main
power is off,
For the PC input signals and screen sizes that this unit is
compatible with, please refer to supplement 2 (page 56).
When connecting to INPUT4
ANALOG
Make separate SYNC connections for a component that
has RGB output separated into 5 output signals: green,
blue, red, horizontal synchronization signal, and vertical
synchronization signal
When connecting to INPUT3
00@00
G _ R HD VD
(ON SYNCJ _NPUTS (HtV SYNCJ
Connect the cable corresponding to the shape of the
input terminal on this unit and the personal computer's
output terminal
Secure by tightening the terminal screws on both units,
After connecting, on-screen setup is necessary,
Please see pages 17 to 19,
Note
Depending on the type of computer model being connected, a
conversion connector or adapter etc provided with the computer
or sold separately may be necessary
For details, please read your PC's instruction manual or consult
the maker or nearest dealer of your computer:
When using INPUT3, set the impedance selector switch
to match the output impedance of the connected
component's synchronization signal
When the output impedance of the component's
synchronization signal is above 75 _, set this switch to
the 22 k£_position
On-screen setup isnecessaryafter connection
Please see pages 17 to 19,
To Next Page
Loading...
