8 Press _,/v to select FORMAT, then press
SET/SELECT.
FORMAT can only be selected when "VIDEO" is set
in step 7,
9 Press ,a,/v to select the input signal format,
The table in the right column on this page shows what
settings are appropriate and available for the type of
connections made
After selecting, press SET/SELECT to enter your
selection
10When the setup is completed, press MENU to exit
the menu screen.
Notes
• Make this setup for each input (INPUT3 and INPUT4)
• When selecting a PC signal or when SIGNAL is set to "PC",
FORMAT cannot be selected
• When FORMAT is set to "COMPONENT" (1 or 2), "G ON
SYNC" cannot be set
• Please refer to page 19 for details concerning G ON SYNC
setup
Set SIGNAL and FORMA] as follows
SET UP
Connected _
component
SIGNAL FORMAT
Component video output VIDEO
of a DTV Set Top Box with
HDTV output
COMPONENT1*
Component video output VIDEO
of a DTV Set Top Box with
COMPONENT 2
SDTV output
Component video output VIDEO COMPONENT 2
of a DVD player: etc
RGB video output of a VIDEO RDB
video deck etc, with RGB
output
RGB video output of a PC PC RDB (Fixed to RGB
when SIGNAL is set
to "PC")
Select either COMPONENT 1 or 2 depending on which setting
provides the most natural picture color for the component
connected
Note
When a DTV Set Top Box is connected, please also refer to
"About DTV Set Top Box connection" on page 14
<ARE1"¢49 > Er/
To Next Page
Loading...
