G ON SYNC setup
The RGB video signal is normally composed of 5 signals;
R, G, B, HD and VD With G ON SYNC connection,
howeveb the signal is composed of 3 signals; R, G (G, HD
and VD combined) and B,
If the component being used is a model where G ON
SYNC connection is carded out, the following on-screen
setup is necessary,
Setup of G ON SYNC connection
1,5
2,3,4
1 Press MENU to display the menu screen.
The menu screen appears
2 Press A/V to select SET UP, then press
SET/SELECT.
3 Press A/V to select G ON SYNC, then press
SET/SELECT.
4 Press _1/_ to select G ON SYNC setting.
After selecting, press SET/SELECT to enter your
selection
5 When the setup is completed, press MENU to
close the menu screen.
Notes
• Make this G ON SYNC setting for each applicable input
(INPUT3 and INPUT4)
• When using this setup, be sure to carefully check the signal
output of the component that you are using. For details, please
refor to the instruction manual supplied with the component
you are connecting
• If the screen becomes bright and turns a greenish COIOFset
G ON SYNC to ON
• G ON SYNC connection is carried out on some Macintosh
computers
To Next Page
Loading...
