60
Channel Inputs
Scan
The [SCAN JACK] is 0-5 Volt CV Input that will Scan through the steps of the sequencer, triggering steps as it reaches
them. It can be used to add glitches to sequences, as a way to generate strange sequence timing behavior.
Reset/1-Shot
The [RESET/1-SHOT JACK] is a gate input that will reset the Sequencer to its First Step. If in 1-Shot Mode, it will also trigger
a 1-Shot.
Repeat
The [REPEAT JACK] is a gate input that will cause the sequencer to stop moving forward and instead repeat the
currently active step until the gate goes low again. The sequencer will keep track of what the active step should have
been, so you won’t lose time when using the [REPEAT JACK].
Chance
The Chance Effects are another of the generative sequencing tools available in the Touch Controller, and we’ll dive
deep on them later. For now, ma
4 Voltage Lab 2 Touch Controller
Scan
Jack
Reset/1-shot
Jack
Repeat
Jack
Chance
Jack
pressure
pitch
cv
cv channel
gate
trigger
reset /
1-shot
repeat chance
scan
envelope
red channel
cv
To Next Page
Loading...
