62
Load and Save
How to Save
To Save a Sequence, hold the [EDIT BUTTON] and press [TOUCH PAD 2] to enter the Save Sequence Screen. Next, press
any [TOUCH PAD] to select a Save Location, and your sequence will be saved to that location.
The Red and Yellow channels have separate save les and can be Loaded and Saved separately.
How to Load
To Load a Sequence, hold the [EDIT BUTTON] and press [TOUCH PAD 1] to enter the Load Sequence Screen. Next, press
any lit [TOUCH PAD] to select a Load Location. If the sequencer is running, the sequence will be loaded the next time
the sequencer resets. If the sequencer is not running, the sequence will be loads immediately.
MIDI Channel
To select a Midi Channel, hold the [EDIT BUTTON] and press [TOUCH PAD 16] to enter the MIDI Channel Screen. Next, use
the [VALUE KNOB] or [TOUCH PADS] to select a MIDI Channel for the current active Sequencer Channel(s).
Midi channels can be different for the Red and Yellow Channels.
A Note on Interactions
Settings are Meant to Play Well Together, and I was meant to be rich by now
With so many tools available, there are a wide range of interactions between modes and settings. Some of them will be
lovely, others will be harsh, and some will manage to be boring! Exploring the complex interactions between the many
tools often feels like an experiment, with unpredictable results. This exploration leads to building a broader
understanding of the Touch Controller, and eventually the intuition of a scientist!
4 Voltage Lab 2 Touch Controller
To Next Page
Loading...
