1080p SIP Vandalproof Door Phone with RFID and PoE
HDP-1261PT
44
The current IP address of the equipment
The current Gateway IP address
The MAC address of the equipment
Select the appropriate network mode. The equipment supports three network modes:
Network parameters must be entered manually and will not be
changed. All parameters are provided by the ISP.
Network parameters are provided automatically by a DHCP server.
If Static IP is chosen, the screen below will appear. Enter values provided by the ISP.
Select the Configured mode of the DNS Server.
Enter the server address of the Primary DNS.
Enter the server address of the Secondary DNS.
Enter the domain of the DNS.
Attention:
1）After setting the parameters, click【Apply】to take effect.
2）If you change the IP address, the webpage will no longer respond, please enter the new
IP address in web browser to access the device.
3）If the system USES DHCP to obtain IP when device boots up, and the network address
of the DHCP Server is the same as the network address of the system LAN, then after the
system obtains the DHCP IP, it will add 1 to the last bit of the network address of LAN and
modify the IP address segment of the DHCP Server of LAN. If the DHCP access is
reconnected to the WAN after the system is started, and the network address assigned by
the DHCP server is the same as that of the LAN, then the WAN will not be able to obtain IP
access to the network
To Next Page
Loading...
Need help?
General
