1080p SIP Vandalproof Door Phone with RFID and PoE
HDP-1261PT
34
4.3 Hotspot
SIP hotspot is a simple utility. Its configuration is simple, which can realize the function of group vibration and
expand thequantity of SIP account. Take one device A as the SIP hotspot and the other devices (B, C) as the
SIP hotspot clients. When someone calls device A, devices A, B, and C will ring, and if any of them answer,
the other devices will stop ringing and not be able to answer at the same time. When A B or C device is called
out, it is called out with A SIP number registered with device A.
Enable or disable hotspot
This device can only be used as a client
The monitoring type can be broadcast or multicast. If you want to
restrict broadcast packets in the network, you can choose multicast.
The type of monitoring on the server side and the client side must be
the same, for example, when the device on the client side is selected
for multicast, the device on the SIP hotspot server side must also be
set for multicast
The multicast address is used by the client and server when the
monitoring type is multicast. If broadcasting is used, this address does
not need to be configured, and the system will communicate by default
using the broadcast address of the device's WAN port IP
Fill in a custom hotspot communication port. The server and client
ports need to be consistent
Fill in the name of the SIP hotspot. This configuration is used to identify
different hotspots on the network to avoid connection conflicts
Sets whether to enable the SIP hotspot function on the corresponding
SIP line
Client Settings:
As a SIP hotspot client, there is no need to set up a SIP account, which is automatically acquired and
configured when the device is enabled. Just change the mode to "client" and the other options are set in the
same way as the hotspot.
To Next Page
Loading...
Need help?
General
