Internet Telephony PBX System
IPX-330/IPX-2100
35
Item Explanation
effective when Call Progress is turned on.
Busy Pattern If busy detect is enabled, it is also possible to specify the cadence of
your busy signal.
Language You can choose a language here; the system will indicate the
incoming calls from this trunk with the voice prompts you to selected.
Answer on Polarity
Switch
For FXO (FXS signal) ports watch for a polarity reversal to mark
when an outgoing call is answered by the remote party.
Hangup on Polarity
Switch
In some countries, a polarity reversal is used to signal disconnect of
a phone line. If the hang up polarity switch option is selected, the call
will be considered "hung up" on a polarity reversal.
3) GSM Trunk
If you have ordered GSM or WCDMA modules for your IPX-2100, the user extensions will be
able to make and receive phone calls from the mobile network. You have to insert the SIM
cards into the SIM slots of the GSM/WCDMA modules (Called IPX-21GS) and then install the
modules to the IPX-2100’s module slots. Antennas should be properly installed and placed in
the open space for better signal reception. After this, power on the IPX-2100 and you’ll be able
to configure GSM trunks the same as you configure FXO trunks.
GSM and WCDMA Specifications
Module Working Frequencies
2GSM GSM/GPRS 850/900/1800/1900MHz
4GSM GSM/GPRS 850/900/1800/1900MHz
2WCDMA UMTS/HSDPA: 850/1900MHz GSM/GPRS/EDGE: 850/900/1800/1900MHz
4WCDMA UMTS/HSDPA: 850/1900MHz GSM/GPRS/EDGE: 850/900/1800/1900MHz
Only IPX-2100 supports GSM trunk.
3.3.2 Outbound Routes
Outbound Routes enable you to tell Planet IP PBX which Trunks (phone lines) to use when
people dial external telephone numbers. A simple installation will direct Planet IP PBX to send
all calls to a single trunk. However, a complex setup could have an outbound route for
emergency calls, another outbound route for local calls, another for long distance calls, and
perhaps even another for international calls.
With the above mentioned possibilities, you may already have several trunks configured in the
To Next Page
Loading...
