NetworkVideoRecorderwithHDMI
NVR‐820/NVR‐1620
7.5 Disk Setup
Once you install a hard disk to the recorder, you would need to initialize it so that it can be
ready for recording. You can obtain basic information about the disk you installed on this page.
To initialize it, simply click the “Format” button.
*Due to the chipset limitation, “Hotswap” is NOT supported for SATA HDD. Please
make sure to power on the SATA external HDD and plug it in to the NVR before
the NVR is turned on.
*The USB HDDs will only be listed on the "USB Backup" and "Hard Disk Status
pages in "System Options". The USB HDDs have to be formatted in advance in
FAT16/FAT32 or EXT3 file system. (FAT32 is recommended)
* Please plug in the USB HDD only after the NVR is fully started. The internal
HDDs will NOT be properly detected if the NVR is powered on with USB HDD
plugged in.
54
To Next Page
Loading...
Need help?
General
