Planet WAP-252N - AP Client and WDS Connection Setup; Setting up AP Client Connection

User Manual of WAP-252N/WAP-552N
-74-
Step2. In AP-2, change the default IP to the same IP range but different from AP-1. In this case, the IP is
changed to 192.168.1.252.
Step 3. In AP-1, go to “Wizard” to configure it to AP Mode. In AP-2, configure it to Repeater Mode.
AP-1
AP-2
Step 4. In AP-2, press Scan AP to search the AP-1. You can also enter the MAC address, SSID, encryption and
bandwidth if you know what they are.