Planet WGSW-24040 - Set up Source MAC and Source IP Binding

User’s Manual of WGSW-24040 / WGSW-24040R
SGSW-24040 / SGSW-24040R
178
4.11.3.4 Set up Source MAC and Source IP Binding
Strictly control the network traffic by only allowing incoming frames that match the source IP and source MAC on specific port.
The settings relate to the currently selected stack unit, as reflected by the page header.
The screen in Figure 4-11-8 appears.
Figure 4-11-8 Set up Source MAC and Secure IP Binding page screenshot
The page includes the following fields:
Object Description
• Port
The logical port for the settings contained in the same row.
• Binding Enabled
Enable or disable the source IP and source MAC binding status for the given
logical port.
• Source MAC Address
The source MAC address for the source IP and source MAC binding.
• Source IP Address
The source IP address for the source IP and source MAC binding.
The ACL configuration wizard is finished, and the new configuration is ready for use.