User Manual of WNAP-W2200
-10-
Chapter 3. Connecting to the AP
3.1 System Requirements
Broadband Internet Access Service (Cable/xDSL/Ethernet connection)
One PoE switch (supply power to the WNAP-W2200)
PCs with a working Ethernet adapter and an Ethernet cable with RJ-45 connectors
PCs running Windows XP, Windows Vista / Win 7, MAC OS X or later, Linux, UNIX or other platforms
compatible with TCP/IP protocols
The above PCs are installed with Web browser.
1. The AP in the following instructions means PLANET WNAP-W2200.
2. It is recommended to use Internet Explore 8.0 or above to access the AP.
3.2 Installing the AP
Before installing the AP, make sure your PoE switch is connected to the Internet through the broadband service
successfully at this moment. If there is any problem, please contact your local ISP. After that, please install the
AP according to the following steps. Don't forget to pull out the power plug and keep your hands dry.
Step 1. Follow the figure below to install the WNAP-W2200.
To Next Page
Loading...
