OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 71
2.4.5 INITIALIZE DATA
ACCESS
Log
LEAK test
Config
Clock
Init data
Return
Init data Initialize Data: Initialize or erase select sections of memory. This is typically only done to restore a
TMS to its factory initialized state or to eliminate memory corruption from Logs. This process is NOT
reversible.
Init Initialize: A description of each section that can be initialized is provided below:
Entry Type: select list
Range Limits: none: Do not initialize any Data.
Inventory: Inventory Log
deLivery: Delivery Log
SALES: Bulk Sales Log
tHEFtS: Thefts Log
Orders: Product Reordering Report
Water rem: Bottom Water Removal Log
tank Leak: In-Tank Leak Test – Detailed Results Log.
Note: Initializing this Log also Initializes the In-Tank Leak Test Scheduling
memory as defined in the Leak Test menu.
LinE PASS: Clears the history from all CC Inputs enabled as Line Pass.
ALArmS: Alarms Log
Events: Events Log
diAL out: Clears the Dial-Out queue. Once the queue is cleared, no further
Dial-Out attempts will be made until a new condition occurs.
Leak Hist: In-Tank Leak Test – History Log
Line Leak: LS300 Line Leak Test Log
All Logs: All Logs
Config: Configuration. All system programming is returned to factory defaults.
ALL: All: Initialize All Logs and System Configuration.
Return: Return: Exits Initialize Data menu
Return Return: Press EDIT (TEST) to exit Init Data menu.
Note: Press STEP (MODE) to return to top of Init Data submenu showing Init (Initialize)
To Next Page
Loading...
