EasyManuals Logo
Home>Polaris>Offroad Vehicle>2002 Snowmobile

Polaris 2002 Snowmobile User Manual

Polaris 2002 Snowmobile
181 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #163 background imageLoading...
Page #163 background image
161
TROUBLESHOOTING
Suspension Troubleshooting
EDGE RMK
Problem Solution (perform only one change at a time)
Rear suspension
bottoms too easily
-Adjust torsion spring blocks
-Increase torsion spring diameter (see your dealer)
-Increase rear shock compression damping by turning screw
clockwise (RMK) or rotating knob towards the right side of the
machine (Vertical Edge)
Rides too stiff in
rear
-Check for binding suspension shafts and grease all pivot points
-Verify sag dimension (refer to set-up decal or page 50)
-Adjust torsion spring blocks
-Install optional torsion springs (see your dealer)
-Decrease rear shock compression damping by turning screw
counter-clockwise (RMK) or rotating knob towards the left side
of the machine (Vertical Edge)
Too much weight
transfer when
climbing
-Verify sag dimension (refer to set-up decal or page 50)
-Adjust torsion spring blocks
-Install optional torsion springs (see your dealer)
-Move limiter strap on front torque arm to high position
-See your dealer for optional mounting
Too little weight
transfer when
climbing
-Verify sag measurement (refer to set-up decal or page 50)
-Adjust torsion spring blocks
-Install optional torsion springs (see your dealer)
-Move limiter strap on front torque arm to low position (refer to
set-up decal or page 50)
-See your dealer for optional mounting
Machine darts from
side to side
-Make sure skis are aligned properly
-Make sure spindles and all steering components are free turning
-Make sure skags are straight on skis
-Install “E-Z Steert skags
Front end pushes -Check for worn skags
-Check for binding suspension shafts and grease all pivot points
-Verify sag dimension (refer to set-up decal or page 50)
-Adjust torsion spring blocks
-Increase torsion spring diameter (see your dealer)
-Increase IFS preload by turning the spring collar to the right
-Move limiter strap on front torque arm to high position
Steering is heavy -Verify sag dimension (refer to set-up decal or page 50)
-Adjust torsion spring blocks
-Install optional torsion springs (see your dealer)
-Decrease IFS preload

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris 2002 Snowmobile and is the answer not in the manual?

Polaris 2002 Snowmobile Specifications

General IconGeneral
BrandPolaris
Model2002 Snowmobile
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals