63
THE PERFECT FIT
Accessories
Wear Strips
To avoid excessive tunnel wear, tunnel wear strips must be installed
whenever track studding is used. Several wear strips are available.
See your dealer for more information.
Some models are manufactured with tunnel wear strips or wear strip
coolers installed. Refer to your Owner’s Manual Supplement to
determine if your model has wear strips.
Wear strips are designed for a specific stud l ength. See your dealer’s
studding chart for recommended traction accessories.
Components as viewed from the rear of the t rack:
1 Top of tunnel
2 Wear strip
3 Track
4 Wearstrip mounting holes
4
1
2
3
Studs longer than 1″ (2.5 cm) on machines equipped with
center coolers will cause center cooler damage.
Whenever wear strips are relocated, be sure there’s adequate
stud clearance to the heat exchangers. Lack of clearance may
result in damage to heat exchangers.
CAUTION
To Next Page
Loading...
