91
OPERATION
Reverse Operation (Electronic)
This reverse will only activate if the engine is below 4000 RPM. Make
sure the vehicle is stopped and the engine is running at idle.
1 Make sure the area behind you is clear.
2 Push t he yellow reverse button on the left hand control for one second
and release. The engine will automatically reduce RPM and start a
reverse rotation. A flashing reverse light on the instrument panel will
indicate the machine is in reverse.
3 Slowly apply the throttle until movement starts and until you are
certain you are in reverse.
NOTE: The maximum engine RP M will be 6000 when in reverse.
NOTE: If the engine has stopped running, the snowmobile will run
forward t he next time it’s started.
Reverse operation, even at low speeds, may cause loss of control,
resulting in serious injury or death. To avoid loss of control, always:
S Look behind before and while backing.
S Avoid sharp turns.
S Shift to or from reverse only when stopped.
S Apply throttle slowly.
WARNING
To avoid personal injury and/or engine damage, do not operate
the electric starter or pull-rope starter while the engine is
running.
CAUTION
To Next Page
Loading...
