Polaris 800 RMK ASSAULT 2011

3.51
Engine/Cooling/Exhaust
3
EXHAUST SYSTEMS
PRO-RIDE DC-CFI-4 Exhaust System
NOTE: Always use the stainless steel (gray) springs
to connect the exhaust pipe to the exhaust manifold.

When removing the exhaust pipe, disconnect the EGT
pro
be wire harness. Do not remove the EGT probe
from the pipe if not necessary.
HEAT SHIELD
EXHAUST PIPE
ZINC-PLATED (YELLOW) SPRINGS
STAINLESS STEEL (GRAY) SPRINGS
GASKET
HEAT SHIELD
A
B
C
D
GASKETS
EXHAUST SEAL
MOUNT BUMPER
(INSTALL LARGE END TO OUTSIDE)
= T
A: EGT Sensor: 32 ft-lbs (44 Nm) Apply anti-seize to
threads.

B: Exhaust Manifold Fasteners: 22 ft-lbs (30 Nm)
C: Silencer Rubber Mount Fastener = 17 ft-lbs (23 Nm)
D: Silencer Bracket Fasteners = 26 ft-lbs (35 Nm)