Repair Manual
Macro 5 SLR Camera
48
2. Reassembly
a. Place the bottom cover onto the camera back making sure that its two (2)
alignment holes properly align with the support posts on the camera back..
b. Using a torx driver, install and tighten the three (3) screws securing the
bottom cover to the camera back.
c. Install the camera back door.
Note: Refer to the user's guide for instructions on how to install the
camera back door.
d. Install the rear cover as explained on page 46.
e. Install the left/right cover assembly as explained on page 42.
To Next Page
Loading...
