Repair Manual
Macro 5 SLR Camera
54
2. Reassembly
a. Place the new the S1/S2 PC board onto its right hand grip support
mounts.
Note: Make sure the large end of the S1 button spring is inserted into the
S1 button before the S1/S2 PC board is placed onto its support
mounts.
b. Using a torx driver, install and tighten the four (4) screws that secure the
S1/S2 PC board to its right hand grip support mounts.
c. Connect electrical cable J19 to the logic PC board.
d. Using a small ty-wrap, secure the S1/S2 electrical cable to the right strobe
cable.
e. Install the left/right cover assembly as explained on page 42.
To Next Page
Loading...
