Repair Manual
Macro 5 SLR Camera
64
2. Reassembly
a. Rotate the turret assembly to its 1x position.
b. Gently slide in the encoder plate making sure its mounting holes align with
the screw holes on the lower turret plate.
Note: Be careful not to break any of its plastic sensor fingers.
c. Using a torx driver, install and tighten the two (2) screws that secure the
encoder plate to the lower turret plate.
d. Rotate the turret assembly to its 3x position.
e. Align the front end of the encoder PC board with its support rails and then
gently push it in until it hits the support locking pins.
f. Using a small flat screwdriver, gently pry up the front end of the encoder
PC board and then push it in until it snaps onto its support locking pins.
g. Connect electrical cable J24 to the logic PC board.
h. Install the left/right cover assembly as explained on page 42.
To Next Page
Loading...
Need help?
General
