Using a Polycom RealPresence Touch Device
Polycom, Inc. 66
End a Call
You can end a call using the RealPresence Touch.
» To end a call, tap Hang Up.
Multipoint Conference Calls
Conference, or multipoint, calls involve at least three different endpoints.
During a multipoint call, multiple sites can see and hear each other. You can also share content in a
multipoint call, just as you can in a point-to-point call.
All systems can participate in multipoint calls. To host multipoint calls, your administrator must install the
multipoint video option key. You can host multipoint calls using a video conferencing system with multipoint
capabilities, or you can use a bridge, such as the RealPresence
®
Collaboration Server 800s.
Note: You cannot host multipoint video calls on RealPresence Group 300 and 310 systems.
How you place a multipoint call depends on whether you're using a RealPresence Group system or bridge
with multipoint capabilities. The number of sites allowed in the call is determined by the capabilities of the
system or bridge hosting the call.
Place a Multipoint Call from Recent Calls
You can use the Recent Calls list to include participants in a multipoint conference call.
1 On the Home screen, tap Place a Call.
2 Under Add Participants > Recent Calls, tap a recent contact in the list. The contact now has a
check mark.
3 Repeat the above step until you have selected all of the recent contacts to add to the conference.
4 Tap . The system dials all of the selected contacts.
Place a Multipoint Call from Contacts
You can call contacts to include them as participants in a multipoint conference call.
1 On the Home screen, tap Place a Call, and then tap Contacts.
2 Tap a contact in the contact list.
3 Continue to add the rest of the contacts to the conference list.
4 To dial all of the contacts in the list, tap .
The paired room system dials all of the selected contacts.
To Next Page
Loading...
