Polysoude PS 406-2 - Programmable Parameters Reference

52-92 PN-0908073 Rev. 11
PS 164-2
THE ART OF WELDING
5. 3. 12. Programmable parameters
For each parameter, the following table shows:
• The synoptic reference (REF.).
• The corresponding name.
• The maximum value programmable.
• The minimum value programmable.
• The increment value that will be added or taken
away when the buttons " + " or " - " are pressed
on the synoptic.
• The default value proposed during the creation of
a new program.
• The units used.
In this column, the abbreviations stand for:
A
Amperage.
V
Voltage.
D
Movement.
/M
A thousandth of the maximum value.
s
A second.
ms
A millisecond.