Polytec MSA-600

To Next Page

To Previous Page

3-17

3 First Steps

Use

Insert either the objective positioner or the objective adapter into the holder.

Refer to the following figures when using the holder.

Figure 3.14: Holder with objective positioner

Main Page

Table of Contents3
Safety Information7
Information on Using These Operating Instructions7
Warning Notices Used7
Notices Used7
Mandatory Signs8
General Safety Information8
Operating the Instrument Safely8
Intended Use8
User Qualification9
Ambient Conditions9
Personal Protective Equipment (PPE)9
Cleaning10
Installing Other Components10
Disposal10
Laser Safety11
Important Warning Notices11
Applicable Standards and Directives12
Equipment12
Information on Laser Class 3R12
Warning Labels on the Instrument13
Lamp Safety15
Important Warning Notices15
Applicable Standards and Directives15
Equipment15
Information on Risk Category 215
Warning Labels on the Instrument16
Electrical Safety17
Important Warning Notices17
Important Notices18
Applicable Standards and Directives18
Warning Labels on the Instrument19
Information on REACH Regulation19
Introduction21
Area of Application21
System Summary21
MSA-600 Options22
Out-Of-Plane-, In-Plane- and Topography Measurements23
Differential Measurements23
First Steps25
Unpacking and Inspection25
Control Elements, Displays, and Connections28
Sensor Head28
Front-End29
Controller31
Data Management System32
Assembly36
Sensor Head36
Objective Adapter/Objective Turret37
Objective Positioner (with MSA-A-TMS Option)38
Holder for Objective Positioner (with MSA-A-TMS Option)40
Cabling43
Connecting the Protective Earth Cable45
Connecting the Hardware49
Connecting the Signals55
Connecting the Mains Cables57
Functional Test57
Out-Of-Plane Vibrations57
In-Plane Vibrations62
Topography Measurement68
Operating71
Software71
Selecting and Exchanging Objectives71
Overview of the Parfocal Lengths of the Objectives72
Troubleshooting75
General Tests75
Problems Connecting to the Signal Generator77
Problems Connecting to the Front-End77
No Laser Beam78
Illumination Module in the Sensor Head Does Not Light up78
Laser Beam Is Not Pointing at the Scan Points78
Measurement Signal Is Faulty79
Measurement Takes an Unusually Long Time79
Technical Specifications81
Harmonized Standards Applied81
MSA-I-620 Sensor Head81
General Data81
Optics85
MSA-F-620 Front-End86
General Data86
Signal Inputs and Outputs87
MSA-E-600 Controller88
MSA-W-620 Data Management System89
General Data89
Industrial PC Configuration89
Data Acquisition89
Function Generator (Only MSA-600-X)89
A-ESG-002 Signal Generator90
Metrological Properties90
Msa-600-X/-U90
Topography Measurements92
Appendix A: Declarations of Conformity93
Index95

Polytec MSA-600 - Page 41

Table of Contents

Related product manuals