1-2
1 Safety Information
1.2 Mandatory Signs
There is a mandatory sign affixed to the instruments which is briefly explained
in the following:
Figure 1.1: Mandatory sign “Refer to instruction manual”
1.3 General Safety Information
1.3.1 Operating the Instrument Safely
Faultless and safe operation of the instruments presume proper transport and
proper storage, installation and assembly as well as careful operation of the
instruments. In addition, it is imperative for the safe operation of the devices
that you pay attention to the safety and warning notices which are listed in
these operating instructions. When assembling, installing and operating the
instruments, make sure that you adhere to the safety and accident prevention
regulations applicable to the respective application.
1.3.2 Intended Use
The instrument is intended for use in a laboratory. It may only be operated
within the limits set in the specifications. It is not necessary to tamper with the
instruments to use them as intended as this will invalidate the warranty.
Any use other than the one described in these operating instructions is not
permitted. Polytec rejects any liability for damages which occur from improper
use.
The instruments are designed in accordance with good engineering practice
to meet state-of-the-art safety requirements, have been tested, and left the
factory in a condition in which they are safe to operate.
To Next Page
Loading...
Need help?
General
