Polytec PSV-I-500 User Manual

ii
emission, EMC standards 7-1
equipment
Laser (Standard)
1-9
Laser (Xtra) 1-9
PSV-W-500 PC 7-14
EU countries, laser warning labels 1-5 , 1-6
F
fitting holes for close-up unit, on the scanning
head
3-9
front lens, on the scanning head 3-9
front-end
control elements (back view)
3-4
control elements (front view) 3-2
signal inputs and outputs (specifications) 7-2
specifications 7-1
FRONT-END, connection on junction box 3-5
functional test, carry out 3-25
G
general tests, troubleshooting 6-2
GENERATOR
jack on the front-end
3-4
SMB jacks on PC 3-7
generator board, on the PC 3-8
geometry scan unit
functional test
4-9
introduction 4-8
technical specifications 7-22
H
housing
front-end (specifications)
7-1
industrial PC (specifications) 7-14
junction box (specifications) 7-13
Standard scanning head, specifications 7-17
Xtra scanning head, specifications 7-18
I
immunity, EMC standards 7-1
information on notices used 1-1
information on operating instructions 1-1
information on warning notices used 1-1
inspection 3-2
installation
assembly
3-12
cabling 3-19
instrument operation, safety 1-2
J
junction box
PSV-E-500, control elements (back view)
3-5
specifications 7-13
L
label
name plate (front-end)
3-4
name plate (scanning head) 3-10
warning label for assembly (scanning
head)
3-11
labels
laser warning labels (Standard)
1-5
laser warning labels (Xtra) 1-6
name plate (junction box) 3-5
name plate (PC) 3-7
laser
object laser (Xtra, specifications)
7-17
pilot laser Xtra, specifications 7-17
Standard, specifications 7-17
laser beam, block 5-1
laser class 2
properties (Standard)
1-7
properties (Xtra) 1-8
warning notices 1-4
LASER LED, operating principle 5-2
laser safety
affixed warning labels
1-5
applicable standards and directives 1-7
equipment, Standard 1-9
equipment, Xtra 1-9
standards applied 7-1
laser stand-by mode, indicate 5-2
laser warning labels
labels (Standard)
1-5
labels (Xtra) 1-6
position 1-6
LASER, LED on the scanning head 3-10
LEFT, connection on junction box 3-5
M
mains connection
connection on junction box
3-5
on PC 3-7
on the front-end 3-4
specifications 7-1 , 7-13 , 7-14
mains switch
on PC
3-7
on the front-end 3-3
measure
frequency range
4-2
select measurement range 4-2
set stand-off distance (PSV-500 Standard) 4-5
start the system 4-1
suitable settings 4-2
metrological properties, DV-04
Standard
7-3
Xtra 7-8
mounting thread
for adapter/quick release plate
3-11

Polytec PSV-I-500 Specifications

General

Brand	Polytec
Model	PSV-I-500
Category	Measuring Instruments
Language	English