Potensic ATOM 2 - Activating the Drone; Firmware Update

•Before upgrading, ensure the drone's batte level is ≥ 30% and the remote controller has at least two
bars of charge. If not, charge them before proceeding with the upgrade.
•Check that the gimbal protector has been removed, and ensure there are no foreign objects around
the gimbal.
•Ensure your mobile device is connected to the internet during the upgrade; otherwise, the rmware
download may fail. If your current mobile device cannot download the rmware, t using a dierent
device or operating system.
• During the upgrade, keep the remote controller and drone within 1 meter of each other and away
from signal inteerence sources such as computers and routers.
• Do not operate the drone or remote controller during the upgrade (e.g., powering o the devices or
plugging/unplugging cables) unless instructed by the App. Keep the devices stationa throughout
the process.
Shutdown
Drone: Press and hold the power button until all the power indicators turn o, then release to complete the
shutdown.
Remote controller: Press and hold the power button until all the power indicators turn o, then release to
complete the shutdown.
•The power buttons on the drone and remote controller are designed to prevent accidental presses.
Once all the batte indicators are on, release the button promptly to avoid automatic shutdown
from holding it down too long.
09
•An internet connection is required for activation. An unactivated drone can only peorm limited
ights up to 3 times.
4.4 Activating the Drone
4.5 Firmware Update
The drone requires activation through the Potensic Eve App before rst use. Power on and connect the drone
and remote controller, then open the Potensic Eve App and follow the on-screen prompts to activate the
drone.
After activation, the current drone and remote controller will be bound together by default. The account used
for activation will have full control over the drone.
When a new rmware update is available, use the Potensic Eve App to upgrade. After connecting the drone
and the remote controller, open the Potensic Eve App. The App will automatically notify you if a new rmware
update is available. It is recommended that users follow the prompts to upgrade for the best experience.