8.2 Pre-Flight Checklist
37
Before ying, the following checks are required:
1. Ensure that the propeller strap and gimbal protector have been removed.
2. Conrm that the sma batte, remote controller, and mobile device are all suciently charged.
3. Ensure that the sma batte and propellers are properly installed. Check for any deformation or
looseness in the propellers and screws.
4. Verify that the front and rear arms of the drone are fully extended.
5. After powering on, check that the camera and gimbal are functioning properly, and that the motors spin
correctly.
6. Check whether the remote controller has the control sticks and mobile device properly installed, and
ensure the remote controller antenna is correctly unfolded. Verify that all buttons are functioning
normally and that Potensic Eve App is operating correctly. Additionally, check all rmware to ensure it
has been updated to the latest version.
7. Ensure the SD card is inseed and the camera lens is clean.
8. Always use original accessories. Using non-original pas may compromise the drone's safety.
9. Check the local weather to ensure it is suitable for ying. Ensure that the ying environment is open and
free from inteerence.
10. Power on the drone on an open and at suace. Wait for the drone to enter GNSS mode before taking
o and pay attention to the HOME point location.
11. Ensure that the drone behavior on signal loss has been preset in the Potensic Eve App, and set the
returnaltitude, maximum ight altitude, and maximum ight distance according to local laws and
regulations.
•Restricted Zones: In Restricted Zones, it is strictly prohibited for any drone to take o or enter the
area. If the drone inadveently enters a Restricted Zone due to extreme weather, system malfunctions,
or other uncontrollable factors, the system will initiate an automatic emergency landing when it
detects the drone in the Restricted Zone. This emergency landing cannot be canceled, but during the
landing process, you can adjust the drone’s landing position using the control sticks to ensure a safe
landing.
•Altitude Zones: In Altitude Zones, the drone’s altitude must be strictly controlled below the specied
limit for that area (with the takeo point altitude as the zero baseline). The drone must not exceed the
altitude limit when entering the altitude zone. The drone can enter the altitude zone as long as it
remains below the maximum allowed altitude.
•Potensic will dynamically update the GEO Zone data based on local laws and regulations, as well as its
own risk assessments, to help users use the drone more safely and legally.
•Please be aware that Potensic cannot guarantee the absolute validity, completeness, or accuracy of
the GEO Zone data; it is provided for reference only.
8.3 GEO Zone
To ensure ight safety and comply with local laws and regulations, ATOM 2 will by default display GEO Zones.
This feature will limit or prohibit the drone’s operations in specic areas, such as Restricted Zones and
Altitude Zones, ensuring that users can operate the drone safely and legally.
Before ying, please check the local GEO zone information in the Potensic Eve App by accessing the map
inteace.
GEO Zones are classied into two types: Restricted Zones and Altitude Zones.