Potensic ATOM 2 - Compass Calibration

5.9.1 When to Peorm Compass Calibration
5.9 Compass Calibration
20
1. Compass calibration is required for rst-time use.
2. Flying the drone more than 500 km (310 miles) away from its last calibration location.
5.9.2 Calibration Procedure
1. When calibration is required, the Potensic Eve App will pop up the calibration inteace automatically, tap
"Sta Calibration", and the drone status indicator will alternatively ash red and green.
2. Hold the drone horizontally and rotate it 360° till the Potensic Eve App shows veical calibration, and the
drone status indicator will alternatively ash blue and green.
3. Hold the drone veically and rotate it 360° around a veical axis till the Potensic Eve App prompts the
calibration completed.
You can also trigger compass calibration manually in the Potensic Eve App under Settings > Calibration >
Compass Calibration.
•Do not calibrate the compass in locations where magnetic inteerence may occur, such as close to
magnetic deposits or large metallic structures such as parking structures, steel reinforced basements,
bridges, cars, or scaolding.
•Do not car objects that contain ferromagnetic materials such as mobile phones near the aircraft
during calibration
•Make sure the drone is at least 1.5 m (4.92 ft) above the ground when calibrating.
•It’s not necessa to calibrate the compass when ying indoors.
•SmaTransfer is unavailable mid-ight.
•If SmaTransfer fails to connect, t the following steps:
1. Ensure that your mobile device's Wi-Fi and Bluetooth are enabled.
2. Keep your mobile device within 1 m of the drone, with no obstacles in between to maintain a
strong Wi-Fi connection.
3. Check if data acceleration or network assistant settings are enabled on your mobile device.
These features may adjust network connections automatically, potentially aecting direct Wi-Fi
transmission between the drone and your device.
•For Android devices: Go to "Settings" and search for keywords like "Data Acceleration," "Mobile
Data Boost," "Sma Network Switching," or "Network Acceleration Engine." The exact names
may va by brand. Locate and disable these features.
•For iOS devices: Go to "Settings" > "Cellular" and scroll down to disable "Wi-Fi Assist."
4. If the current environment has strong Wi-Fi inteerence, t moving to a location with less
inteerence.
After completing these steps, resta the app and the drone, then attempt to reconnect. If the issue
persists, please contact online customer suppo.