Potensic ATOM 2 - Settings

34
7.3 Settings
Safety
Flight Settings
•Enable/disable Beginner Mode: when enabled, the drone will be restricted to ying within a cylindrical
space with a radius of 30 m and a height of 30 m, and it will be limited to ying only in Video Mode. After
installing the propeller guards, make sure to enable Beginner Mode.
•Flight Mode (Video/Normal/Spo)
Return to Home (RTH)
•Set drone behavior on signal lost: Return/Land/Hover.
Return: The drone will automatically ascend to the preset return altitude and then return to the HOME
point when the remote controller signal is lost.
Land: The drone will automatically land in place when the remote controller signal is lost.
Hover: The drone will hover in place when the remote controller signal is lost.
•Set the return altitude.
•Enable/disable Dynamic HOME Point: after enabling, when the distance between the takeo point and the
remote controller exceeds the preset distance (and the drone is more than 100 m away from the takeo
point), you will be prompted to choose whether to set the current position of the remote controller as the
new HOME point. Using a device with poor GPS accuracy may compromise the user experience. If your
device’s positioning accuracy is inadequate, we recommend either switching to a better mobile device or
disabling this feature.
•Enable/disable Silent Return: after enabling, the remote controller will no longer beep when the drone
enters RTH mode in the future. To stop the current beeping, simply press once the power button on the
remote controller.
Viual Fence
Set the maximum ight altitude and distance of the drone.
General Settings
•Set the mesurement system (metric or imperial) and enable/disable the ight safety tips.
•Enable/disable Takeo with One Hand: After enabling, users can launch the drone with one hand. In Mode
1 (right hand throttle), press the C2 button and simultaneously pull down the right control stick for 2s to
unlock the motors. Release the control stick rst to take o; otherwise, release the C2 button rst to stop
the propellers from spinning. In Mode 2 (left hand throttle), press the C1 button and simultaneously pull
down the left control stick for 2s to unlock the motors. Release the control stick rst to take o; otherwise,
release the C1 button rst to stop the propellers from spinning. Custom control stick mode does not
suppo Takeo with One Hand.
Advanced Safety Settings
•Enable/disable Emergency Propeller Stop Mid-Flight: after enabling, you can press and hold the C2 and
RTH buttons for 2s simultaneously to stop the motors only in an emergency situation. Note: Stopping the
motors mid-ight will cause the drone to crash. Please make sure that the area below the drone is clear
and open.
Remote ID: please write the relevant data required by UAS Remote ID in accordance with local laws and
regulations.
Batte Information: view batte information such as temperature, current, voltage and cycle counts.