Potensic ATOM 2 - Page 60

Changes or modications not expressly approved by the pay responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Pa 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful inteerence, and
(2) This device must accept any inteerence received, including inteerence that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Pa 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
inteerence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful inteerence to radio
communications. However, there is no guarantee that inteerence will not occur in a paicular installation. If this
equipment does cause harmful inteerence to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to t to correct the inteerence by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set foh for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
IC Statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with󶀅Innovation, Science and
Economic Development󶀅Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause inteerence.
(2) This device must accept any inteerence, including inteerence that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d' en
compromettre le fonctionnement.
ISED Radio Frequency Exposure Statement:
The device has been evaluated to meet general RF exposure requirements. The device can be used in mobile
exposure conditions. The min separation distance is 20 cm.
ISED Déclaration d'exposition aux radiofréquences:
L'appareil a été évalué pour répondre aux exigences générales en matière d'exposition aux RF. L'appareil peut
être utilisé dans des conditions d'exposition mobiles. La distance de séparation minimale est de 20 cm.
Operation of this device is restricted to indoor use only. (5150-5250MHz)
Le fonctionnement de cet appareil est limité à une utilisation en intérieur uniquement. (5150-5250MHz)
For Canada: The frequency stability of all transmission frequencies of U-NII-1, U-NII-3 meets the requirements of
RSS-Gen Issue 5, Section 6.11, and the manufacturer states that their transmissions remain within the U-NII-1,
U-NII-3 bands.
Pour le Canada: La stabilité de fréquence de toutes les fréquences de transmission U-NII-1, U-NII-3 répond aux
exigences de la norme CNR-Gen, édition 5, section 6.11, et le fabricant déclare que leurs transmissions restent
dans les bandes U-NII-1, U-NII-3.