Need help?Do you have a question about the Powerware 5125 and is the answer not in the manual?
This UPS contains LETHAL VOLTAGES. All repairs and service should be performed by AUTHORIZED SERVICE PERSONNEL ONLY.
This UPS contains its own energy source (batteries). The output receptacles may carry live voltage even when the UPS is not connected to an AC supply.
Batteries can present a risk of electrical shock or burn from high short-circuit current. Observe proper precautions.
Procedures for inspecting the UPS and its packaging for damage during shipment.
Description and diagrams of the rear panel connectors and ports for different UPS models.
Instructions for installing the UPS unit into a 19-inch rack.
Instructions for setting up the UPS in a standalone cabinet configuration.
Procedures for powering the UPS unit on and off.
Instructions on how to start the UPS without utility power.
How to perform a self-test on the UPS to check its operational status.
Explanation of the different operating modes indicated by the UPS front panel.
Information on optional communication modules that enhance UPS networking capabilities.
Explanation of receptacle sets controllable by power management software for orderly shutdown.
Details on the REPO port for remote shutdown and its installation procedure.
Guidelines for maintaining the UPS and batteries for optimal performance and longevity.
Instructions for proper storage of the UPS and its batteries, including recharge recommendations.
Procedure for hot-swapping the electronics module without interrupting power to connected equipment.
Detailed steps and safety precautions for replacing the UPS batteries.
Procedure for performing a self-test after installing new batteries.
Information and warnings regarding the proper disposal and recycling of used batteries.
Details on input voltage range, power levels, and output receptacles for various models.
Physical specifications including weight and dimensions for the UPS and EBM.
Operating and storage conditions, humidity, altitude, and safety compliance standards.
Details on battery configuration, type, charging, monitoring, and run times.
Explanation of audible alarms and front panel indicators for UPS status and fault conditions.
Procedure for temporarily silencing audible alarms for existing faults.
Contact information and required details for obtaining technical assistance or repairs.
To Next Page
General
