PR4000 9mt 4x1000W METAL HALIDE
TL073-11-02-03
01-02-2011
CAUSE
Injection pump wear.
REMEDY
Do not use poor quality fuel as it will cause wear of the pump. Check the fuel injection pump
element and replace it if necessary.
CAUSE
Overheating of moving parts.
REMEDY
Check lubricating oil system.
Check to see if lubricating oil filter is working properly or replace it.
FAULT
• Ouput voltage unstable.
CAUSE
Irregular engine speed.
REMEDY
The engine is set at the exactly speed (1500 r.p.m.), in case of unsetting contact the
manufacturer.
CAUSE
The alternator is defective.
REMEDY
Replace the alternator and eventually contact directly the manufacturer.
FAULT
• The machine stops with the oil low pressure signal lamp ignited.
CAUSE
The oil level is low.
REMEDY
Verify the level and add oil if necessary.
CAUSE
The pressure switch is defective.
REMEDY
Replace the pressure switch.
To Next Page
Loading...
