Ether232Plus User Guide 1 Before You Start
02-CML000057 Precidia Technologies Inc. 7
1.5 Software Requirements
You will need terminal software (or a dumb terminal) to locally configure the unit.
Please see Section 2.2, Setting Up the Terminal for further details.
1.6 Configuration Requirements
The following settings represent the basic requirements for configuring the unit. You
may need to configure other settings depending on your set-up and the protocol you
are using.
Ethernet Settings
• IP Address, Subnet Mask, Gateway: These are the addressing information of the
unit and the network. Leave at zero if using a DHCP (Dynamic Host Configuration
Protocol) server to configure the IP addresses.
Serial Port Settings
• Protocol: Used by the attached device
• Port Setting: Port settings of the attached device
• Local Port: Port number on the unit (as required)
• Remote Port and Remote IP: Port number and IP address of remote host (as
required)
Security Settings
• Remote Password: Must be configured to enable remote access and configuration
To Next Page
Loading...