5 Configuring the Security Settings Ether232Plus User Guide
40 Precidia Technologies Inc. 02-CML000057
2 Choose
Remote Password
from the Security Settings sub-menu.
You are prompted to enter a remote access password with a maximum of 8 charac-
ters.
3 Do not type any characters. Press
Enter
to clear the password.
The password is displayed as (not set) in the Security Settings sub-menu.
5.3 Web Server
The Web Server enables or disables access to the static Web page, and the dynamic
Status page and System Log stored in the unit. The default setting is “enabled”. The
pages are accessible through your Web browser and are described in Section 7,
Accessing System Information‚ on page 57.
If you enable the Web Server you can also define the Access Userid and Password to
restrict access to the dynamic Status Page and System Log. If you enable the Web
Server and do not configure Access Userid and Access Password (default), anyone
who knows the IP address of the unit can access the pages through a Web browser.
N
OTE
: HTTP authentication schemes for passing the user ID and password to the
HTTP daemon include Basic and Digest Access Authentication. Most Web browsers
support one or both authentication schemes and should function correctly. Update
your browser if problems occur.
To enable or disable the Web Server:
1 Choose
Security Settings
from the Device Settings menu.
2 Choose
Web Server
from the Security Settings sub-menu.
You are prompted to enable or disable the Web Server, as shown below.
3 Type the letter that corresponds to the desired setting and press
Enter
.
The web server allows access to the set of static pages loaded in to the unit
(see the system menu) and to the various dynamic pages such as system status
and system log.
A. enabled B. disabled
Choose desired setting or press ESC to cancel:
Web Server Options
To Next Page
Loading...