Precidia Ether232Plus - Timeout During Configuration

To Next Page

To Previous Page

2 Setting up the Ether232Plus Ether232Plus User Guide

12 Precidia Technologies Inc. 02-CML000057

2.4 Timeout During Configuration

After 4 minutes of inactivity the timeout notification appears under the prompt, as

shown below. Any unsaved changes will be lost.

You must then press and hold the recessed CONFIGURE button for several seconds, or

re-establish your remote telnet connection, to access configuration and re-enter your

changes.

OTE

: Typing any character, or typing

“?”

to refresh the screen, will restart the

4-minute timer.

Table 2.1: Device Settings Menu Options

No.

Menu Item Description

1) Ethernet

Configure the local network information before the

device is placed on a network so it does not cause a

problem with the existing LAN, or configure auto-

matically with a DHCP server.

2) Serial Port

Configure host addresses and the protocols being

used by the serial device.

*) Save Current

Configuration

Save changes and exit from configuration mode.

Resets the unit.

-) Exit Configuration

(no save)

Exit from the configuration mode without saving

any changes. Resets the unit if configuring locally.

$) Security Settings

Configure all passwords (Console, Remote and

Web Server), IPsec, and SNMP.

#) System Settings

For administrator only. Perform Web page and

firmware downloads, and view system information.

?) Refresh this Screen

Refresh the current Configuration screen.

Change which option?

!timeout! (changes not saved)

Timeout Notification