5 Configuring the Security Settings Ether232Plus User Guide
42 Precidia Technologies Inc. 02-CML000057
Clearing the Access Password
1 Choose
Security Settings
from the Device Settings menu.
2 Choose
Access Password
from the Security Settings sub-menu.
3 Do not type any characters. Press
Enter
to clear the password.
The password is displayed as (not set) in the Security Settings sub-menu.
5.6 SNMP Server
The SNMP Server enables or disables the SNMP function in the Precidia unit. The
default setting is “enabled”.
To enable or disable the SNMP Server:
1 Choose
Security Settings
from the Device Settings menu.
2 Choose
SNMP Server
from the Security Settings sub-menu.
You are prompted to enable or disable the SNMP Server, as shown below.
3 Type the letter that corresponds to the desired setting and press
Enter
.
5.7 SNMP Settings
Precidia products support SNMPv2c. SNMP (Simple Network Management Protocol)
is a protocol for viewing network statistics and settings. An SNMP management
system consists of a manager (remote) and an agent (Precidia device) using UDP as
the communication protocol.
The Precidia SNMP agent supports MIB-II, and allows GET (read) commands for
gathering information, SET (write) commands for managing how the information is
gathered, and trap (notification) generation for alerting the Network Manager when
selected or unusual events occur.
To access the SNMP Settings, choose
SNMP Settings
from the Security Settings sub-
menu.
The SNMP server allows access to many internal statistics as well as the values
seen in the system status page.
A. enabled B. disabled
Choose desired setting or press ESC to cancel:
SNMP Server Options
To Next Page
Loading...