Ether232Plus User Guide 6 System Settings
02-CML000057 Precidia Technologies Inc. 51
Refer to the Help Guides Local Software Download and Remote Software Download at
http://www.precidia.com/products/documentation.html for instructions.
6.4 Display System Status
The System Status page allows you to view useful statistics about the unit. This infor-
mation includes system uptime, activity through the serial port (Port #1), and network
port settings. The System Status page displays the same information as the Status Web
page.
You can easily determine the IP address of the unit through the System Status page,
even if it is dynamically allocated. The first Local address listed under Network
Routing is the IP address of the unit.
Choose
Display System Status
from the System Settings sub-menu.
The status information appears, an example of which is shown below.
See Section 7.1, System Status‚ on page 57 for a description of the System Status
page.
6.5 Dump System Log
Dump System Log allows you to review all activity that has occurred on the
Ether232Plus since it was configured, or since the Delete System Log option was
used. The dump may require a few minutes to complete.
Ether232Plus Status:
Current time is 2004-03-12 20:26:10
System Uptime
Up 0 days, 0:07:57
Load Average: 5sec=19% 30sec=7% 5min=4% 30min=0%
Firmware Revision: 4.04.00 (2004-03-05)
Port #1 [serial] (transparent/tcp-server, idle)
Received Transmitted
Bytes: 0 Bytes: 0
Packets: 0 Packets: 0
Avg-BpP: 0 Avg-BpP: 0
Network Routing
Local Network Subnet Mask Gateway Iface Pkts-I
n Pkts-Out Pkts-Err
100.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 ipsec 0
0 0
0.0.0.0 0.0.0.0 0.0.0.0 0.0.0.0 ipsec 0
0 0
192.168.1.30 192.168.1.0 255.255.255.0 eth 142
66 0
127.0.0.1 127.0.0.0 255.0.0.0 lo 0
0 0
Please hit <return>:
Example of the System Status Page
To Next Page
Loading...