7 Accessing System Information Ether232Plus User Guide
60 Precidia Technologies Inc. 02-CML000057
Port #1
This section describes the configured serial port in the Ether232Plus. It consists of a
header line and a table showing the data received and transmitted.
N
OTE
: If the serial port is not configured, or incorrectly configured, this section does
not appear on the System Status page.
The header contains the following information:
• Port type (null, if no terminal connected, or serial) in brackets
• the Protocol (data formatting and session mode), and connection status in paren-
theses
Connection status can be connected, connecting, or idle. The information below the
header shows the number of bytes, the number of packets, and the average bytes per
packet received and transmitted by the unit.
Network Routing
This section reveals how the system is handling the data going through the Precidia
unit in the same style as the “print-route” command. Table 7.2 describes each param-
eter in the Network Routing section.
Table 7.2: Network Routing Parameters
Parameter Description
Local
The IP Address of the unit (configured in Ethernet Settings or
obatined through DHCP).
Network
Address
The network address, derived from the IP address and subnet mask,
for which this entry applies.
Subnet
Mask
The Subnet Mask for which this entry applies (configured in Ether-
net Settings or obatined through DHCP).
Gateway
The Gateway (router) address for which this entry applies (config-
ured in Ethernet Settings or obatined through DHCP).
Iface
The interface used to connect to the remote host. eth = Ethernet
Pkts-In
Total number of packets received by the unit since the last reset.
Pkts-Out
Total number of packets sent by the unit since the last reset.
Pkts-Err
Total number of error packets received by the unit since the last
reset.
To Next Page
Loading...