iPocket232 User Guide 2 Setting Up the iPocket232
23-CML000293 iPocket232 Inc. 11
2.3 Setting Up the Terminal
Once the iPocket232 is connected to your PC, you can access the Configuration
screen using terminal software.
You may use any terminal emulation software as HyperTerminal, which comes
standard with Windows operating systems, or Procomm Plus (Symantec). For further
help on using Hyper Terminal, please refer to the Using HyperTerminal Help
Guide at: http://www.iPocket232.com/products/documentation.html.
IMPORTANT! WINDOWS NT/2000/XP USERS:
If using HyperTerminal to perform firmware upgrades, or to download static Web
pages to the IPocket232 unit, you need to use the latest version of
HyperTerminal. To obtain your free HyperTerminal upgrade, visit
http://www.hilgraeve.com.
1 Start your terminal program.
2 Select the correct COM port in your terminal program (usually Com1 or Com2).
3 Configure the terminal with the following settings:
• Bits per second: 9600 (required)
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: Hardware
N
OTE
: The Data Bits, Parity, Stop Bits, and Flow control settings listed above are
recommended settings. Configuration can be accessed using any settings at 9600 bps.
4 Using a ballpoint pen or similar item, press and hold the recessed
CONFIGURE
button at the rear of the unit for several seconds, until the initial Configuration
screen appears (as shown below).
If the screen does not appear, refer to Appendix B:, Troubleshooting and Support.
To Next Page
Loading...