iPocket232 User Guide 2 Setting Up the iPocket232
23-CML000293 iPocket232 Inc. 13
Table 2.1: Device Settings Menu Options
Configure the local network information before
the device is placed on a network so it does not
cause a problem with the existing LAN, or
configure automatically with a DHCP server.
Configure host addresses and the protocols being
used by the serial device.
Save Current
Configuration
Save changes and exit from configuration mode.
Resets the unit.
Exit Configuration
(no save)
Exit from the configuration mode without saving
any changes. Resets the unit if configuring locally.
Configure all passwords, IPsec, and SNMP.
For administrator only. Perform Web page and
firmware downloads, and view system information.
Refresh the current Configuration screen.
2.5 Timeout During Configuration
After 4 minutes of inactivity the timeout notification appears under the prompt, as
shown below. Any unsaved changes will be lost.
Change which option?
!timeout! (changes not saved)
Timeout Notification
You must then press and hold the recessed CONFIGURE button for several seconds, or
re-establish your remote telnet connection, to access configuration again and re-enter
your changes.
N
OTE
: Typing any character, or typing “?” to refresh the screen, will restart the 4-
minute timer.
To Next Page
Loading...