Precidia ipocket232 - Terminal Type (Telnet Protocol Only); Local Port

4 Configuring the Serial Port Settings iPocket232 User Guide
23-CML000293 iPocket232 Inc. 29
3 Type the letter that corresponds to the desired option and press Enter.
4.4 Terminal Type (Telnet Protocol Only)
If you select Telnet in the Protocol setting, you can enter the type of terminal you are
using. If the Terminal Type is unknown, this parameter may be left at (
unset)
. The telnet
server will set a default type, but it is more effective to set it yourself. If the terminal type
is incorrect, the full screen telnet applications will not work properly. To enter or change
the Terminal Type (Telnet only):
1 Choose Serial Port from the Device Settings menu.
2 Choose Terminal Type from the Serial Port Settings sub-menu.
You are prompted to enter the type of attached terminal, as shown below.
The "terminal type" is not simply an arbitrary string of characters describing the type of
device attached to the serial port. It is a specific name that will be recognized by the
remote host and used by it to decide how to control that type of terminal.
Common terminal types are "dumb", "ansi", "vt100", and "vt102".
Enter type of attached terminal:
Entering the Terminal Type 3
Type in the terminal type and press Enter.
4.5 Local Port
Local Port is the port number that listens for incoming connections. This option must be
set if the iPocket232 will ever receive a session initiated from an outside source (in
tcp(tunnel), tcp-server, and udp modes). If the iPocket232 will only be used to initiate
sessions, this setting can be left at 0 (tcp-client mode). To enter or change the Local
Port:
1 Choose Serial Port from the Device Settings menu.
2 Choose Local Port from the Serial Port Settings sub-menu.
You are prompted to enter the port number on the local system.
3 Type the port number at the prompt and press Enter.