5 Configuring the Security Settings iPocket232 User Guide
23-CML000293 iPocket232 Inc. 40
1 Choose Security Settings from the Device Settings menu.
2 Choose Remote Password from the Security Settings sub-menu.
You are prompted to enter a remote access password with a maximum of 8 characters.
3 Do not type any characters. Press Enter to clear the password.
The password is displayed as (not set) in the Security Settings sub-menu.
5.3 Web Server
The default setting is <enabled>.
The Web Server enables or disables access to the Web, Status and System Log pages
stored in the unit. The pages are accessible through your Web browser, and are described
in Section 7, Accessing System Information‚ on page 57.
If enabled, you can also define the Access Userid and Password to restrict access to the
Status and System Log pages.
I
MPORTANT
! If enabled, but you do not configure the Access Userid and Access
Password (default), anyone who knows the IP address of the unit can access the pages
through a Web browser.
N
OTE
: HTTP authentication schemes for passing the user ID and password to the HTTP
daemon include Basic and Digest Access Authentication. Most Web browsers support one
or both authentication schemes and should function correctly. Update your browser if
problems occur.
To enable or disable the Web Server:
1 Choose Security Settings from the Device Settings menu.
2 Choose Web Server from the Security Settings sub-menu.
You are prompted to enable or disable the Web Server, as shown below.
The web server allows access to the set of static pages loaded in to the unit (see the
system menu) and to the various dynamic pages such as system status and system log.
A. enabled B. disabled
Choose desired setting or press ESC to cancel:
Web Server Options
To Next Page
Loading...