iPocket232 User Guide 3 Configuring the Ethernet Settings
23-CML000293 iPocket232 Inc. 17
3.1.2 Static - (No DHCP) IP Address Settings
If you decide not to allow DHCP to automatically detect and assign your iPocket232’s IP
Address, you may enter the IP Address manually. To enter or change the IP address:
1 Choose Ethernet from the Device Settings menu.
2 Choose IP Address from the Ethernet Settings sub-menu. You are prompted to enter
the IP address of the device.
3 Type the unique IP address at the prompt (in the format xxx.xxx.xxx.xxx) and press
Enter.
3.2 Subnet Mask (Static — No DHCP)
The subnet mask is used to determine what subnet an IP address belongs to. The mask
allows a router to determine the network and host addresses, and forward data packets
correctly. To enter or change the Subnet Mask:
1 Choose Ethernet from the Device Settings menu.
2 Choose Subnet Mask from the Ethernet Settings sub-menu. You are prompted to
enter the subnet mask of the device.
3 Type the subnet mask at the prompt (in the format xxx.xxx.xxx.xxx) and press Enter.
3.3 Gateway (Static — No DHCP)
If the device will be communicating with a host that is not on the local subnet, you must
specify the router address (gateway) that will forward data to the destination. If the
destination is within the LAN and can be accessed without passing through a router,
you can leave this field blank (0.0.0.0). This setting is the default gateway. To enter or
change the Gateway:
1 Choose Ethernet from the Device Settings menu.
2 Choose Gateway from the Ethernet Settings sub-menu.
You are prompted to enter the IP address of the gateway.
To Next Page
Loading...